Oxygen Regulator

This oxygen regulator is a single-stage, dual-gauge regulator designed for Hobbyweld oxygen cylinders. In an oxy-acetylene set, it’s the part that controls your oxygen: one gauge shows roughly how much gas is left in the cylinder, the other shows the working pressure you’ve set, so you can run a steady flame for cutting, welding, brazing or soldering.

The gauges are custom units reading up to 137 bar, which lines up with the Original Hobbyweld cylinders. Used alongside an acetylene cylinder and its own regulator, it gives you the oxygen side of the kit at a controlled, readable pressure.

Compressed-gas regulators should be fitted with the right fitting for your cylinder and used carefully, following Hobbyweld’s own guidance rather than anything improvised. If your cylinder is a different capacity or pressure, check the regulator suits it before ordering.

We deliver across our defined postcode area around Reading, so check your postcode is covered before ordering, or call the yard on 0118 9242888 if you’d like help matching the regulator to your gas.

FAQs

What cylinders does the oxygen regulator fit?

It’s made for Hobbyweld oxygen cylinders, with custom gauges reading up to 137 bar to match the Original range. Check it matches your cylinder’s pressure and fitting before use. If you’re unsure, call us before ordering.

What do the two gauges show?

It’s a dual-gauge regulator. One gauge gives a rough read of the oxygen left in the cylinder, the other shows the working pressure you’ve set at the torch. Together they help you run a steady flame for cutting and welding.

Do you deliver welding gear to my area?

We deliver across a defined set of postcodes around Reading, Berkshire and into parts of South Oxfordshire and Buckinghamshire. The area is limited, so check your postcode is covered first, or call the yard on 0118 9242888 to confirm.